How To Assemble A Tent Quickly

Table of contents:

How To Assemble A Tent Quickly
How To Assemble A Tent Quickly

Video: How To Assemble A Tent Quickly

Video: How To Assemble A Tent Quickly
Video: Step - By - Step | How To Set Up a Tent 2024, December
Anonim

Over the past couple of decades, the latest materials and technologies have been introduced into the tourism industry. Today you have the opportunity, going into nature, not to lug a tent weighing 10-12 kg, but to take a light and durable camp house, the weight of which will be almost 3 times less. These tents do not get wet and are not blown by the wind. You can easily set it up alone, and, if necessary, assemble the tent quickly by packing it in a backpack or a special case.

How to assemble a tent quickly
How to assemble a tent quickly

Instructions

Step 1

The most common of modern tents are domed, hemispherical tents, which are installed on frame arches. Most of them are two-layer, with an outer awning and an inner tent, which is attached to it with special hooks. These tents are erected using steel pegs.

Step 2

It is best to assemble the tent when it is dry. Therefore, if it rained before, the awning must be dried so that the material does not become moldy. Walk around the perimeter of the tent and remove all the pegs from the loops, untie the stretch marks. To assemble your tent quickly, immediately fold the pegs and frame poles into their dedicated bags.

Step 3

Remove the top tarpaulin by pulling the frame bars out of it. Close all zippers and fold it in half. Place the folded tarp on the ground next to the tent. Check the inside of the tent for any items left.

Step 4

Shake out branches, leaves and debris if they get inside by turning this part of the tent inside out. Fasten the mosquito nets and zippers, fold the bottom of the inside of the tent in half so that the fabric is inside. Fold it in half again along the longer side of the resulting rectangle.

Step 5

Place this rectangle in the middle of the tarpaulin you removed and folded. Start rolling the inside of the tent into a tube, tucking it inward at the edge of the tent. Try to keep the resulting "cocoon" as dense as possible. Then put it in a tent cover or backpack. Place the pouches with pegs and wire frames with it. Close the zipper of the cover if the tent will be transported in it. Assembling the tent will take you no more than 3-4 minutes, even if you do it alone.

Recommended: